Modern Civil Engineering in Trend of the Sustainable Infrastructure Development
Trans Tech Publications Ltd (Verlag)
978-3-03835-619-6 (ISBN)
Collection of selected, peer reviewed papers from the
eco-AWAM International Conference on Civil Engineering 2015 (eco-AICCE’15), September 9-11, 2015, Kuala Lumpur, Malaysia.
The 114
papers are grouped as follows:
Chapter 1: Geotechnical Engineering;
Chapter 2: Structural Engineering;
Chapter 3: Highway and Transportation Engineering;
Chapter 4: Environmental Engineering; Chapter 5: Water Resources Engineering;
Chapter 6: Construction Management
Preface, Committees and Organizer
Chapter 1: Geotechnical Engineering
Adverse Effects of Soil Grouting on Sandy Soils
The Study of Soil-Roots Strength Performance of Soil Slope by Using Guinea Grass
Rock Overstressing in Deep Tunnel Excavation of Pahang-Selangor Raw Water Transfer Project
Groundwater Inflows Characterization in the Pahang-Selangor Raw Water Transfer Tunnel Using δ2H and δ18O as Tracers
Finite Element Analysis of Tunnelling Induced Deformation towards Pile Foundation
Modification of Published Prediction Model of Ground Motion due to Sumatra Subduction Earthquakes for the Application in Peninsular Malaysia
Seismic Microzonation for Denizli Metropolitan Area, Turkey
Development of a New Tsunami Generator
The Study of Flow Characteristics of Newtonian and Power-Law Non-Newtonian Fluids by Dam-Break Flow Model
Wave Transmission over the Low-Crested Sand Container Breakwaters
The Study of Mengkuang Dam`s Chute Spillway by Physical Modeling
Chapter 2: Structural Engineering
Identification of Dynamic Characteristics of a Historical Church in Armenia Using Microtremor Survey Technique
A Microscopic Dynamics of Crowd Behavior for Crowd Evacuation Simulation in the Event of a Tsunami Disaster
AHP Based Thermal Comfort Assessment through Passive Design Allocation in Tropical School Offices
An Overview of Non – Engineered Buildings Roofing System Failure under Wind Loads
Assessment of Adhesion between RPC Overlay and Existing Concrete Substrate
Cylindrical Section with Helically Arranged Perforations Inspired by Nature
Density Assessment of Heat Treated Malaysian Hardwood Timber: The Case of Kapur (Dryobalanops spp.) and Keruing (Dipterocarpus spp.)
Dispersion of Multi-Walled Carbon Nanotubes in Portland Cement Concrete Using Ultra-Sonication and Polycarboxylic Based Superplasticizer
Drying Shrinkage of Fly Ash Mortar Mixed with Seawater
Effect of Curing Methods on Carbonation Depth of Rubberised Fibre Mortar
Effect of Diameter on Fire Exposed Concrete-Filled Double Skin Steel Tubular (CFDST) Columns under Concentric Axial Loads
Effect of Footfall Induced Vibration on Footbridges
Effect of Ground Granulated Blast Furnace Slag on Compressive Strength of POFA Blended Concrete
Effects of Coal Bottom Ash on the Compressive Strength of Portland Cement Mortar
Effects of Footfall Induced Vibrations on Concrete and Composite Floors
Effects of Thickness of Ultra High-Performance Fiber Concrete Wrapping on the Torsional Strength of Reinforced Concrete Beam
Effects on Concrete Bonding of Green Universiti Sains Malaysia Reinforced Concrete (GUSMRC) at Elevated Temperatures
Estimation of Tsunami Force for Onshore Buildings in the Northwest Coast of Peninsular Malaysia
Experimental Study on Lateral -Torsional Buckling of Triangular Web Profile Steel Section
Experimental Study on Reinforced Concrete Box Beam Strengthened by CFRP under Combined Action
Experimental Study on the Effect of Macroroughness on Tsunami Flow and Loading of Building
Influence of Crumb Rubber on Impact Energy of Steel Fiber Concrete Beams
Influence of Initial Silica Modulus of Na2SiO3 on the Compressive Strength of Alkali Activated Ultrafine Palm Oil Fuel Ash Based Mortar
Influence of People Walking on Floor Performance due to Low Level Vibration
Influence of Silica Fume Inclusion on the Compressive Strength Development of High Strength Concrete Containing High Volume of Palm Oil Fuel Ash
Lightweight Building Materials of Geopolymer Reinforced Wood Particles Aggregate – A Review
Mechanical Properties of Mortar Modified with Cement Treated Tyre Crumb and Oil Palm Fruit Fibre
Nonliear Analysis of Reinforced Concrete Structures Considering Plastic Deformation
Nonlinear Bending Analysis for Steel Purlin with Perforation
Numerical Models of Hysteretic Steel Damper with a Hollow Diamond Shape for Energy Dissipation
Performance of Recycled Aggregate Containing POFA as Additives for Cement
Practical Method for Damage Evaluation Based on Point Estimate Considering Uncertainty of Structural Properties
Precast Concrete Closed Spandrel Arch Bridge System as Viable Alternative to Conventional Beam Bridge System
Properties of Cement Mortar Consisting Raw Rice Husk
Strength Development in Cement Admixed Fine-Grained Dredged Marine Soils
Study on Fluid Transport Properties between Normal Concrete Substrate and Green-USM-Reinforced Concrete (GUSMRC) Containing Ultra Fine Palm Oil Fuel Ash (U-POFA) as Repair Material
UHPFRC as Repair Material for Fire-Damaged Reinforced Concrete Structure – A Review
Strength Prediction of Double-Lap Bolted Joints of Woven Fabric CFRP Composite Plates Using Hashin Formulations
Trends and Development of Precast Concrete Closed Spandrel Arch Bridge Systems
Chapter 3: Highway and Transportation Engineering
Behavior of Cold Recycled Mixes in the Range of Low Temperatures – Experimental Study
Impact of Ageing and the Stability of Adhesion Additive on Moisture Susceptibility and Adhesion
The Effects of Bituminous Binders on Cold Recycled Mixes Prepared by the Foamed Bitumen Technology
Effects of Calcium Carbonate and Treated Palm Oil Fly Ash on the Rheological Properties of Asphalt Mastic
Effects of Wax Additive on the Rheological Properties of Asphalt Binder
Life Cycle Assessment for Pavement Sustainable Development: Critical Review
Mode Shifting Behavior for the Inter-Island Passenger Transportation in the Western Visayas Region, Philippines
Locating Problematic Road Sections: Comparisons between Crash Data and Composite Index Method
Volume-Delay Function in Trip Assignment
Evaluating the Effect of Mixing Process on Nano-Clay Modified Binders Using the Pull-Off Test Method
Physical and Rheological Properties of Aged Bitumen Rejuvenated with Waste Engine Oil
The Alternative Trip Generation Model for Flat/Apartment/Condominium and Low Cost Housing Subcategories
Time Gap Evaluation due to the Existence of Heavy Vehicles on Urban Expressways
Using Nanopolyacrylate and Nanocomposite as Binder Modifiers for Stone Mastic Asphalt (SMA)
Assessment of Queue Length and Delay at Toll Plaza Using Microscopic Traffic Simulation
Effect of Roadside Development on the Safety of Intersections without Signals
Chapter 4: Environmental Engineering
Biological Treatment of Poultry Slaughterhouse Wastewater by Using Different Fibers
A Comparative Study of Floc and Sludge of Leachate under Different Types of Coagulants
A Comprehensive Review of Environmental, Physical and Socio-Economic (EPSE) Criteria for Spatial Site Selection of Landfills in Malaysia
An Analysis of Pro-Environmental Attributes towards Adolescents in Penang Using Extended Theory of Planned Behaviour
Comparative Study of Basic, Acid and Reactive Dyes Adsorption onto Rubber Seed-Coated Activated Carbon
Effect of Ni/Co Ratio on Bimetallic Oxide Supported Silica Catalyst in CO2 Methanation
Enhancing BOD/COD Ratio of POME Treatment in SBR System
H2S Emissions within Vicinity of Swine Farming Area in Nibong Tebal, Pulau Pinang, Malaysia
Influence of Hydraulic Conductivity and Organic Matter Content in Different Bioretention Media on Nutrient Removal
Influence of Operating Conditions on the Persulfate Oxidation of Textile Waste Water at Ambient Temperature
Iron and Manganese Removal from Groundwater Using High Quality Limestone
Landfill Leachate Treatment by Bentonite Augmented Sequencing Batch Reactor (SBR) System
Odour Intensity Assessment at Different Area of a Palm Oil Mill Using Olfactometry Method
Optimization of COD and Color Removal for Matang’s Landfill Leachate Treatment by Using Polyaluminum Chloride
Optimum of Treatment Condition for Artocarpus heterophyllus Seeds Starch as Natural Coagulant Aid in Landfill Leachate Treatment by RSM
Oxygen Uptake by Biological Processes inside Oxidation Ditch
Performance of some New Bacterial Isolates on Biodegradation of Libyan Light Crude Oil Using Agro-Industrial Wastes as Co-Substrates
Performance of Ozone/ZrCl4 Oxidation in Stabilized Landfill Leachate Treatment
Pharmaceutical Removal from Synthetic Wastewater Using Heterogeneous - Photocatalyst
Natural Organic Matter and Disinfectant By-Products (DBPs) Formation Potential in Agriculture Area in Malaysia
Removal of Suspended Solids, Chemical Oxygen Demand and Color from Domestic Wastewater Using Sago Starch as Coagulant
Review on Applications of Nanoparticles in Landfill Leachate Treatment
Effects of Substituted Transition Metals (Me:Cr3+, Mn3+, Fe3+ and Mo) on the Fe2+/Modified Silica in the Oxidative Degradation of Reactive Black 5
Sustainable GIS Based-ANN's Solution for Landfill Suitability Analysis
Waste to Wealth: Recovery of Recyclable Items and Biodegradable Wastes from Night Markets at Seberang Perai Selatan, Penang
Optimization of HCO3- Production Reflect to CaСo3 Precipitation for Self-Healing by Bacillus sphaericus
Chapter 5: Water Resources Engineering
Riverbank Filtration Site Suitability Selection Using Spatial Data Techniques: Case Study for Kota Lama Kiri, Kuala Kangsar
Multiple Regression Model Using Performance Indices for Storage Capacity of a Reservoir System in Johor Catchment
Modelling Critical Period of a Reservoir System Using Performance Indices in Johor Catchment
Rainwater Availability Assessment for Tourism Development: A Case Study of Turtle Islands Park, Sabah
Public Participation and Response towards Water Resources Management Options in Gaza Strip, Palestine
Computational Investigation of Inlet Baffle Height on the Flow in a Rectangular Oil/Water Separator Tanks
Effect of Utilizing Different Building's Roof Material on Rainwater Harvesting System’s Payback Period, Water and Energy Savings, and Carbon Dioxide Emission Reduction
Analysis of Flow Characteristics in Sewerage System
Studying Effect of Riverbank Filtration (RBF) on Ground Water Using ‘Time-Lapse Electrical Resistivity Imaging’ at Kuala Kangsar, Perak
The Potential and Benefits of Artificial Barrier Application at RBF
Model Study for Upgrading of Sungai Belibis Pump Sump
Evaluation of Water Quality Index (WQI) Performance in Newly Constructed Free Water Surface (FWS) Constructed Wetland for Stormwater Treatment
Subsurface Characterization Using Ground and Underwater Resistivity Techniques for Groundwater Abstraction
A Study on the Characteristic and Properties of Riverbank Soil Samples as RBF Natural Materials from Sungai Perak, Kota Lama Kiri, Kuala Kangsar, Perak Darul Ridzuan, Malaysia
Direct Determination of Groundwater Direction and Velocity Using Colloidal Borescope at Jenderam Hilir, Selangor
Chapter 6: Construction Management
Improved Water Services and Malaysian Household’s Willingness to Pay: A Descriptive Analysis
Developing a DMS (Dredged Marine Sediments) Management Framework for Beneficial Reuse in Artificial Land Creation
Delphi Technique Procedures: A New Perspective in Construction Management Research
Motivations and Limitations of Prefabricated Building: An Overview
Quantification of Concrete Waste Generated in Housing Construction Sites via Site Sampling: Development of a Multiple Linear Regression Model
Rethinking Sustainable Housing Maintenance Delivery
The Study of the Implementation of Bridge Management System in Sabah
| Erscheinungsdatum | 02.12.2015 |
|---|---|
| Reihe/Serie | Applied Mechanics and Materials |
| Zusatzinfo | Illustrations, unspecified |
| Verlagsort | Zurich |
| Sprache | englisch |
| Maße | 170 x 240 mm |
| Gewicht | 1350 g |
| Themenwelt | Technik ► Bauwesen |
| Technik ► Elektrotechnik / Energietechnik | |
| Technik ► Maschinenbau | |
| Technik ► Umwelttechnik / Biotechnologie | |
| Wirtschaft ► Betriebswirtschaft / Management ► Projektmanagement | |
| ISBN-10 | 3-03835-619-0 / 3038356190 |
| ISBN-13 | 978-3-03835-619-6 / 9783038356196 |
| Zustand | Neuware |
| Haben Sie eine Frage zum Produkt? |
aus dem Bereich
